VisuNet IXD
Mechanical Installation
2
0
2
0
-0
4
29
Installation Steps
1.
Start to thread 18 x socket head screws into the threaded holes on the panel mount brackets.
2.
Attach the lower panel mount bracket (1) to the IXD using 5 x washers and 5 x socket head
screws. Apply a small amount of Loctite 243 to the 5 x screws prior to installation. Tighten the
screws to 6 Nm.
3.
From the front side of the panel, position the IXD with the opening and hang lip of the lower
panel mount bracket over the bottom edge.
4.
Slide the IXD assembly all the way to the left and attach the upper panel mount bracket (2) to
the IXD using 6 x washers and 6 x socket head screws.
5.
Apply a small amount of Loctite 243 to the 6 x screws prior to installation. Tighten the screws to
6 Nm.
6.
Tighten the clamping screws in a uniform criss-cross pattern until the gasket is fully
compressed. Torque will vary.
7.
If the panel is made out of thin or soft material, use the optional panel mount stiffener (3) to
avoid uneven pressure when the clamping screws are tightened. This component is ordered
separately.
3.7
Wall Mount Assembly
Required Components
•
IXD prepared for wall mounting with adapters and VESA bracket
•
Wall bracket with 4 x loose screws
•
Loctite 243
Required Installation Tools
•
3 mm hex key for attaching the wall bracket screws to the VESA bracket
•
4 mm hex key for attaching screws to the VESA bracket
Note
The clamping screws on the lower panel mount bracket can be hand-tightened
to hold the IXD in place while the upper panel mount bracket is installed.
Warning!
Risk of personal injury and equipment damage
Lifting the IXD housing on your own may cause injury or damage the device.
