VisuNet IXD
Mechanical Installation
2
0
2
0
-0
4
25
Installation Steps
1.
Preassemble the cam levers (1). Place the two components on each threaded cam shaft as
shown below, with the curved side of the rubber washer fitted against the cam lever. Ensure
that the headless screw is positioned approximately even with the head of each cam lever.
2.
Bring the keyboard tray into position such that the center holes (2) are aligned with the lower
threaded holes on the sides of the yoke frame.
3.
Position the inner washers for the shoulder screws (2) between the keyboard tray and the yoke.
Start to thread the shoulder screws on each side.
4.
Apply a small amount of Loctite 243 to the shoulder screws prior to installation. Tighten the
shoulder screws to 4.5 Nm.
5.
Gently lower the keyboard tray against the pedestal.
6.
Position the inner and outer washers for the cam assemblies (1) with the upper threaded holes
on the keyboard tray.
7.
Tighten the cam levers until they can be clamped tightly against the keyboard tray to hold the
tray in position. A flat-head screwdriver can be used as needed to adjust the position of the
headless screws on the cam levers to keep the studs protruding slightly through the ends of the
cam levers.
