2
0
2
0
-0
4
16
VisuNet IXD
Mechanical Installation
3.5.2
Preparing the Pedestal
For floor mounting with a yoke bracket, the preferred pedestal option is PEDESTAL-XX00-124-
3-304-TRN-N0. The pedestal is shipped with a pre-installed rotating coupling and a ground
cable, which is attached to the pedestal tube.
Figure 3.2
Tool needed for removing the set screws out of the pedestal in case of IXD: hex wrench
size 3 mm
Preparing the Pedestal for Connection
1.
Bend the grounding cable and place it within the pedestal tube.
2.
Remove the cable glands at the bottom of the pedestal.
3.
Put the gland nut and ferrule of the cable gland on the cable and slide them down the cable
away from the pedestal. Keep the nut and ferrule on the cable to tighten them in a later
installation step.
Note
The pedestal comes with bolts attached to the coupling. Remove and discard these bolts prior
to installation.
