15
INTELLIFLO
®
VS+SVRS and INTELLIPRO
®
VS+SVRS Variable Speed Pump Installation and User’s Guide
14
INTELLIFLO
®
VS+SVRS and INTELLIPRO
®
VS+SVRS Variable Speed Pump Installation and User’s Guide
Settings: Password
When the Password feature is enabled, the IntelliFlo
®
VS+SVRS Pump will enter into password
protection mode for a preprogrammed amount of time after the last button is pressed. The entered
password is any combination of four (4) digits.
To access the Password menu:
1. Check that the green power LED is on.
2. Press the
Menu
button. “Settings” is displayed.
3. Press the
Select
button. “Pump Address” is displayed.
4. Use the
Up
or
Down
arrow button to scroll to “Password”.
5. Press the
Select
button. The default setting is “Disabled”.
6. Press the
Select
button to change the setting.
7. Press
Up
or
Down
arrow button to change the setting to Enabled”.
8. Press the
Enter
button to save the setting.
9. Press
Down
arrow button. “Password Timeout” is displayed.
Factory default time is 10 minutes, this means the pump will go into Password Protection
mode 10 minutes after the last control panel key press.
10. Press
Select
to change time setting from 1 minute to 6 hours.
11. Press the
Enter
button to save the setting.
12. Press
Down
arrow button. “Enter Password” is displayed.
13. Press
Select
to change the setting.
14. Press
Left
or
Right
arrow button to move cursor and press up and down arrow to change
password number to desired setting.
15. Press the
Enter
button to save the setting. To cancel any changes, press the
Escape
button to
exit edit mode without saving.
16. Press the
Escape
button to exit.
Password Protection
Password: The default for this setting is disabled, which means the pump does not have password
protection. When this feature is enabled, for a preset amount of time after the last button is pressed, the
pump’s display will prompt for the password before allowing access to the pump’s control panel and
buttons The password must be a four (4) numeric digit password. Write down the password and keep in
a secure place.
• When the pump is password protected the pump can always be turned off by pressing the
Start/Stop
button.
• When running the pump in manual mode it can not be turned back on with the press of the
Start/Stop
button.
• Pressing the
Start/Stop
button when the pump is off will return it back to the
Running
Cycles Mode
and will run at the next scheduled run time. If the present time is within the
scheduled run time the pump will run the scheduled speed.
• All functions including programming are disabled in Password Protection Mode.
• If any button other than the
Start/Stop
button is pressed, the screen reads Enter Password.
• When Password Protection is enabled there is a key icon displayed in the upper left side of
the LCD.