11
INTELLIFLO
®
VS+SVRS and INTELLIPRO
®
VS+SVRS Variable Speed Pump Installation and User’s Guide
10
INTELLIFLO
®
VS+SVRS and INTELLIPRO
®
VS+SVRS Variable Speed Pump Installation and User’s Guide
Menus
The menu descriptions are as follows:
Settings: Pump Address
The pump address needs to be changed when there is more than one pump on an automation system.
Addressing the pump allows the automation system to know which pump to send a command to.
The “Pump Address” setting is used when the pump is connected via the RS-485 COM port to an
IntelliTouch
®
, EasyTouch
®
, SunTouch
®
Control System or IntelliComm
®
Communication Center.
The default pump address is #1. When connected to an EasyTouch or SunTouch control system or
IntelliComm communication center, the pump only communicates with address #1. The pump address
can be set from 1-16. However, the IntelliTouch control system can communicate to four (1-4) pumps.
Note: IntelliFlo
®
VS+SVRS or IntelliPro
®
VS+SVRS Pumps cannot be connected in series with
other pumps.
To access the Settings menu:
1. Be sure the green power LED is on and the pump is stopped.
2. Press the
Menu
button. “Settings” is displayed.
3. Press the
Select
button. “Pump Address” is displayed. The Factory default setting is address
“1.”
4. To change the pump address, press the
Select
button. The first digit “1” selected.
5. Press
Up
or
Down
arrow button to change the address number from 1-16.
6. Press the
Enter
button to save the setting. To cancel any changes, press the
Escape
button to
exit edit mode without saving.
7. Press the
Escape
button to exit.
Settings: Set Time
Use “Set Time” to set the pump’s system time. The pump’s system clock controls all scheduled start
and stop times, functions, and programmed cycles. The system clock can store the correct time for up
to 96 hours after power is shut off. The pump will retain the time memory for 96 hours before a reset is
needed.
To access the Set Time menu:
1. Check that the green power LED is on.
2. Press the
Menu
button. “Settings” is displayed.
3. Press the
Select
button. “Pump Address” is displayed.
4. Use the
Up
or
Down
arrow button to scroll to “Set Time”
5. Press the
Select
button. The cursor will appear in the Minutes column.
6. Press
Up
or
Down
arrow button to set the time.
7. Press the
Enter
button to save the setting. To cancel any changes, press the
Escape
button to
exit edit mode without saving.
8. Press the
Escape
button to exit.
