Pentair FLECK 9000 SXT, Руководство по установке

Страница: 49 / 118

Installer manual Fleck 9000 SXT - Programming
Ref. MKT-IM-020 / C - 21.11.2019 49 / 118
Regeneration cycles:
• B1: First backwash (for dF2b regeneration flow);
• B2: Second backwash (for dF2b regeneration flow);
• BD: Brine draw;
• BF: Brine fill;
• BW: Backwash;
• RR: Rapid rinse.
4 . Data display .
5 . PM indicator • Appears if controller set in US unit.
6 . Flow indicator • Flashes when outlet flow is detected.
7 . x1000 indicator • Appears when the displayed number is bigger than 9999.
8 . Programming
icon
• Appears in programming modes.
6.2 Commands
Info
Menus are displayed in a defined and incremental order.
If none of the buttons are pushed for 5 minutes in the Programming mode, or if there is
a power failure, the controller returns to Service mode without saving.
Mandatory
In order to store the new settings in the programming mode, it is necessary to go
through all the parameters !
1. Press to pass to the next step.
2. Use and to adjust the values.
6.3 Setting the time of the day (TD)
Set the time in the system.
1. Press and hold or until the programming icon
replaces the service icon and the parameter display reads TD.
2. Set the time with or .
3. Press to validate the selection and return to the service
mode, or wait for 10 seconds.
6.4 Basic programming
6.4.1 Basic programming mode chart
Parameter Options Definition Note
DO Days override 0 to 99 Day -