Pentair Fleck 5800 XTR, Руководство по установке

Страница: 51 / 126

Installer manual Fleck 5800 XTR - Programming
Ref. MKT-IM-006 / E - 12.11.2019 51 / 126
Info
On metered units, the "Treatment" step on the regeneration cycle wheel will flash
when water is flowing through the unit.
7 Rapid Rinse • Water flows from the top of the vessel to the bottom of the
vessel to rinse the media.
8 Tank Refill • Brine tank is refilled with water.
9 Treatment • The unit is treating water.
10 Day and time • Displays the currently programmed day of the week and time.
This button will flash at the start-up and if the supercapacitor
is discharged
11 Next scheduled
regeneration • Displays the time to next scheduled regeneration, or volume
remaining until regeneration in meter systems.
12 Backwash • Water flows from the bottom of the vessel to the top of the
vessel to clean and mix the media.
13 Draw • Brine is drawn into the media and then slowly rinsed out.
14 Pause • Valve comes back in service position to allow brine
preparation after refill. Shown if variable refill/brining
regeneration flow has been selected in master setting.
15 Custom • Shown if custom regeneration flow has been selected in
master setting.
16 Home • Displays the home screen.
17 USB connect • Allows you to connect the controller to a PC via a USB cable
for field programming or download of diagnostic parameters
via PC (Field Programmer application required).
18 Arrows • Displayed in the upper-left and upper-right corners of the
screen, these arrows allow you to navigate from one screen
to another.
• Allow you to change the values of certain settings when
programming the controller.
Info
Settings on previous screen are not saved unless is pressed.
19 Alarm • Displayed when an error has occurred; accompanied with an
audible alarm. Press to silence the audible alarm.
20 Error • Displayed when an error has occurred. Press to display the
error screen for more detailed error information.