Pellas X HYBRID 44, Руководство пользователя

Страница: 18 / 39

16 | P a g e
3.4. External feeder
Pic.5. Feeder’s construction.
Fuel feeder connects fuel hopper with burner. It is made of steel pipes, galvanized or
stainless steel with diameter 60mm or 76mm and 2m or 3m long (it is related to the size of
burner). There is a steel spiral inside the pipe driven by electrical engine 230V AC with gearbox.
The motor is connected using the power suitable socket located on the burner’s controller. The
feeder lower part is mounted in the lower part of the fuel hopper and its upper part is connected
to the burner with the flexible polypropylene pipe.
Feeder assembly:
1. Connect both pipes (1) and (2) with the bolt M8 (3) and nut M8 (4);
2. Insert the pin (6) in the shaft hole (8), and then screw the spiral (5) onto the pin (6)
and tighten with the nut (7);
3. Put the feeder’s cap (10) onto the motor pin (9);
4. Slide the shaft (8), including the mounted spiral, onto the motor pin (9) and secure
with the set screw (11);
5. Slide the spiral into the pipe inside so that it terminates at the half of the inlet hole
(figure below) and screw the motor (9) to the pipe flange with the bolts (12) and nuts
(13).