PedigreeTechnologies.com | Support: (701)-499-0022
9
Direct Wire Installation Option
CameraView
Mitac
STEP ONE
Cut off the 10-pin molex connector from the power
cable.
STEP THREE
The
Yellow
wire
(power)
should be
connected to a constant 12-24VDC power source
found at the key source or the fuse panel.
(Circuit taps are provided in the hardware kit if
needed, however soldering and using inline fuses is
the recommended connection.)
STEP TWO
The
Black
wire
(ground)
should be securely fastened
to a grounded screw or chassis ground.
STEP FOUR
The
Red
wire
(ignition)
is the ignition event wire that
is best installed direcly to 12v switched ignition
wire.
Ensure that power to the ignition wire is availabe
ONLY when the vehicle ignition is turned on. All
makes and models of vehicles are different - we
recommend knowledge of the particular vehicle’s
constant and ignition wiring prior to installation.
