Hardware Installation
27
Models 2603, 2621, and 2635 User Manual
3
• Initial Configuration
Hardware Installation
If you are already familiar with OnSite Series Router installation and configuration, this chapter will enable you
to finish the job quickly. Installation consists of the following:
•
Preparing for the installation (see section “What you will need”)
•
Installing the T1/E1 WAN, X.21, or V.35 interface cable (see section
“Interface cable installation”
)
•
Hooking up network cables, verifying that the unit will power up, and running a HyperTerminal session
(see section
“Installing the Ethernet cable”
on page 35)
CAUTION
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
•
Changing the IP address from the factory default setting (see section
“IP address modification”
on page 35)
•
Launching a web browser in preparation for configuring the modem (see
“Web Operation and Configura-
tion”
on page 36)
What you will need
•
OnSite Series High Speed Router
•
Ethernet cable with RJ45 plugs on each end (included with router)
•
DB9-RJ45 adapter (included with router)
•
RJ45/RJ45 straight-through cable for connecting to control port (included with router)
•
PC computer with HyperTerminal or equivalent VT-100 emulation program, or an ASCII terminal (also
called a
dumb
terminal
) capable of emulating a VT-100.
Interface cable installation
An OnSite Series router comes with a T1/E1 WAN, V.35, or X.21 interface. Refer to the appropriate section to
install an interface cable on your OnSite router:
CAUTION
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
•
Model 2603 router (see
“Installing an interface cable on the OnSite 2603’s T1/E1 interface port”
on
page 27)
•
Model 2621 router (see
“Installing an interface cable on the OnSite 2621’s X.21 interface port”
on page 29)
•
Model 2635 router (see
“Installing an interface cable on the OnSite 2635’s V.35 interface port”
on page 31)
Installing an interface cable on the OnSite 2603’s T1/E1 interface port
The OnSite Models 2603/K and 2603/T come with a selectable T1/E1 WAN interface (see
figure 4
). Located
on the back of the OnSite, the T1 and E1 interfaces are presented on an RJ-48C connector with selectable line
Содержание OnSite 2603
Страница 23: ...23 Chapter 2 Product Overview Chapter contents Introduction 24 Applications Overview 25...
Страница 38: ...38 Chapter 4 Ethernet LAN Port Chapter contents Introduction 39 LAN Connections 39 Ethernet Port 39...
Страница 120: ...120 Appendix C Cable Recommendations Chapter contents Ethernet Cable 121 Adapter 121...
