Paton ProTIG-200, Руководство пользователя

Страница: 44 / 51

- 43 -
PATON ProTIG DC TIG/MMA
set ("Start current"), welding current is regulated depending on pressing the pedal (the
more pressed the pedal, the higher current), if the pedal is pressed to the lower limit, the
maximum current value will be set, which is set using the "Main current" parameter. The
use of the pedal allows changing the current from the value "Start current" to "Main
current" in the welding process.
4.8 Function of remote control of welding current
This function allows adjusting the welding current in TIG mode remotely, either using a
pedal or using a torch, which should be equipped with a potentiometer of 10 kOhm. When
using a torch, to activate the function it is necessary to switch on the parameter
« REMOTE
CONTROL », changing its value on « ON ».
To start working with a pedal, you need:
•
connect the pedal to the device into the socket for the button on the torch;
•
switch the device to the mode of operation with the "BUTTON MODE" => "PED"
pedal;
•
set the parameters of the welding mode.
Note Parameters such as “ Rise Time ” , “ Fall Time ” , and “ End Current ” do not need to be
set, since they are not involved in the welding process. The pedal can be used in TIG AC and
TIG DC modes, as well as in pulse mode.
Pedal connector diagram
S1 - burner button connection
R1 -
connection of a 10 kΩ potentiometer
5. MANUAL ARC WELDING USING COATED ELECTRODE (MMA)
In order to start operation in ММА mode, it is necessary to:
- connect cable of electrode holder to socket « - » ( В ), and cable of mass holder – to
socket «+» ( А ). Here, the direct polarity of welding is set;
- connect netowrk plug to power source;
- switch network switcher to the position
«I»;
- using the button «Mode» ( 1 ) select ММА mode on the device;
- adjust the main welding current;
- adjust the additional mode parameters;
- press the button
«Enter».