Paton ProTIG-200, Руководство пользователя

Страница: 47 / 51

PATON ProTIG DC TIG/MMA
- 46 -
WARNING! The network plug should correspond to the supply voltage and the
consumption current of the welding machine (see Technical data). According to safety
rules, use rosettes with a guaranteed grounding.
7. CARE AND MAINTENANCE
WARNING! Before opening the device, it should be switched off and disconnected
from the power mains. It is necessary to allow discharging the inner circuits of the device
(about 10 minutes) and only then perform other actions. While leaving the workplace, put a
plate that forbids switching on.
In order to save the serviceability of the device for many years, it is necessary to
follow the relevant rules for operation and carry out the safety inspection at the specified
time intervals (see the section "Safety Rules").
8. STORAGE RULES
The preserved and packed machine is stored in storage conditions 4 according to
GOST 15150-69 for 5 years.
The unpreserved machine should be stored in dry closed rooms at air temperature
not lower than plus 5 °C. In rooms should not be va pors of acids and other active
substances.
9. TRANSPORTATION
The packed device can be transported by all modes of transport that provide its
storage in compliance with the rules of transportation set for the transport of a certain
mode.
10. TECHNICAL DATA
WARNING!
If the source is designed for special power supply, its technical data
are given on the identification shield on the back panel. In this case, a network plug and a
network cable should be selected according to the used voltage.
Parameters
ProTIG-200
AC/DC
ProTIG-315-400V
AC/DC
Rated mains current 50/60 Hz, V ~230
3х380
3х400
Varying mains voltage, V 190-260 ±10%
Efficiency (at rated current), % >80% >80%
Range of regulating welding current,
А
5 – 200 10 – 315
Welding current (DC) at:
5 min / 40%
ТН
5 min / 100% ТН
200
126 315
180