ParTech 7200, Инструкция по эксплуатации, Страница: 31 / 50

7200 Monitor Instruction Manual
14.4 Bleeper
This option allows the bleeper to be turned on or off, a small tick indicates the current setting. To change the bleeper
setting, use the

keys to select the required setting and press OK . Press MENU to exit the bleeper menu.
14.5 Backlight
The backlight can be set to one of three modes, On, On after key press (the backlight stays on for 5 seconds after a
key is pressed) or Off. The current backlight mode is indicated by a small tick, to change the backlight mode, use the

keys to select the required mode and press OK . Press MENU to exit the backlight menu.
14.6 Language
This facility is used to select the operating language of the instrument and is configured using the list select method of
data entry.
14.7 Change Password
The user password used when the instrument is locked and unlocked can be adjusted using this menu. The first stage
in changing the password is to enter the existing password, which is done using the

keys. Once the old
password has been entered, press the OK key to proceed to the next stage, which is the entry of the new password.
The new password can be entered using the

keys and pressing the OK key will store the new password. At
any stage whilst the password is being changed, pressing the MENU key will exit the menu and the old password will
be unchanged.
Note: The factory default password is 1000, if the original password has been forgotten please contact
Partech technical support.
14.8 Reset Instrument
It is sometimes necessary to restore the default values for all the user configurable parameters such that the
instrument is in a known state. To load the user defaults, select Reset Instrument and press
OK . To prevent accidental
use, the user password must be entered prior to confirming the operation.
167300IM-Issue 12 Issue Date 14/10/2014 Page 31 of 50