INSTALLATION & MAINTENACE MANUAL
RCOe2100/03.06
25
3.6 - Handling
For motors handling during assembly and disassembly from the application, the following procedures are
recommended.
3.6.1 – Handling of Motor Types MR – MRE – MRA / MRD – MRDE – MRDA / MRV –
MRVE – MRVA
Lifting by means of Nylon belt
Harness the motor (1) by means of a Nylon belt (2) as shown here below
Lifting with a
Nylon belt +
metal ring
The belt size must be chosen according to the motor weight (motors’ weight can be
found in the relevant “technical catalogue”).
Use a metal ring (3) to "throttle" the belt (2), adjusting the height of the metal ring
before tensioning the cable.
Lifting by means of a dedicated lifting tool
Connect the motor (1) to the dedicated lifting tool (2), as shown in the following
picture, and handle the motor by using an adequate lifting system. The dedicated
lifting tool can be supplied by Parker Calzoni s.r.l. upon request. The tool (2) must be
connected to one of the two drain ports (3) and to one fixing hole (4) of the front
flange.
