28.
Cut the covering from the slots in the top of the
fuselage and horizontal stabilizer for the vertical
stabilizer. Fit the vertical stabilizer to the fuselage and
using it as a guide, cut and remove the covering from
the fuselage/horizontal stabilizer where it meets the
vertical stabilizer. Ensure the vertical stabilizer is
straight and perpendicular to the horizontal stabilizer
and glue in place.
29.
Sand a 45 degree bevel on the leading edge of the
rudder. Sand and cover the rudder. Use tape to join
the rudder to the vertical stabilizer and fuselage.
30.
Insert and glue the carbon rods for the wing hold
downs.
31.
Install motor, speed controller and servos for the
rudder and elevator. Install control horns on rudder
and elevator and connect to servos.
