70.
Fit and glue formers F1, F2 and F6 to the float sides.
71.
Sheet the top of the float with 1/16” balsa, 1/32”
balsa can be used if desired.
72.
It is recommended to sheet the bottom front of the
float with 3/32” balsa. Sheet the bottom rear of the
float with 1/16” balsa, 1/32” balsa can be used if
desired.
73.
Glue scrap balsa to the front and back of the float.
The front should have at least ½” and the rear should
have at least ¼”. Sand the blocking flush to the float
sides and top/bottom. Round over the front blocking
as desired.
It is recommended to seal the balsa before covering.
