60.
Glue the 1/32” balsa aileron bottom (with the ‘T’
notches to the other side of the ply aileron core.
Round the leading edge of the aileron (edge with
notches) and then sand a taper on both sides of the
trailing edge so that the aileron has a symmetrical
airfoil profile. Cover the aileron and then cut away the
covering from the hinge slots.
61.
Cut six 1” pieces of 1/32” carbon rod and insert into
the aileron hinges.
62.
Fit the aileron hinges into the hinge slots as shown.
Carefully glue the rods into the slots but be careful
not to glue the aileron hinge to the carbon rod.
63.
Cut away the covering from the hinge slots in the
trailing edge of the bottom of the wing. Fit and glue
the aileron hinges to the bottom of the wing.
