Park Air T6M, Руководство пользователя, Страница: 20 / 70

SWITCHING ON AND OFF
To switch on the base station:
(1) Ensure the Supply switch fitted to the base station's rear panel is set to on. Note that there is
no front panel indication as to whether the rear panel supply switch is on or set to standby.
(2) Press the front panel Power button for approximately one second until the display reads ‘On’.
Then release the button.
(3) Check that a warbling sound is heard for a few seconds and then a channel frequency is
displayed.
(4) The base station is now ready for use.
To switch off the base station, press the Power button until the display reads ‘Off’. Then release the
button. Note that this action removes power only from the radio module; power to other modules is
removed when the rear panel Supply switch is set to standby.
Warning!
Neither the Power button, nor the rear panel Power switch, isolates the input supply from the
equipment. Lethal voltages are still present in the base station's internal power supply. To
ensure safe working during maintenance, the ac and dc input supplies must be
disconnected from the base station.
Note ...
Always switch off the rear panel Power switch, and allow at least 10 seconds, before disconnecting
the ac and dc supply connectors. If this is not done, when next switched on the base station may
revert to previous channel and mode settings, and not those that were active immediately before
switching off.
T6M Base Station User Guide
Page 20
Base Station Front Panel Power Button Location