7
Installing and Setting Up the FrameSaver SLV
To complete the installation, you must:
Verify that self-test passed.
Configure the FrameSaver unit.
Connect to the network and continue configuration.
Connect to the modem.
Connect to the ISDN, if applicable.
Connect to the DSX, if applicable.
Connect to the DTE(s).
Check the connections.
NOTE:
Follow these instructions as they are presented. The system should be configured
first before connecting the cables. Otherwise, installation time will be increased.
Verifying that Self-Test Passed
Before starting to configure the FrameSaver unit, confirm that the unit passed the
self-test.
1. Follow this menu selection sequence from the Main Menu, pressing Enter after
each selection:
Main Menu
→
Status
→
System and Test Status
2. Check the Self-Test Results column (in the center of the System and Test Status
screen).
– If
Passed
appears, the FrameSaver unit successfully completed the self-test.
– If any failure messages appear, reset the unit by removing and reinserting the
NAM. The unit will perform the self-test again. If the failure reappears, call your
service representative for assistance.
