10
7. Map the DSX-1 time slots to the network time slots.
8. Save the configuration.
Setting Up Data Ports
1. Configure the physical characteristics of the port.
Configuration
→
Data Ports
→
Physical
2. For multiport FrameSaver units, select a port.
Helpful Hint:
Press the spacebar to display the port number and press Enter.
3. If Port-2 will be used on a multiport unit, enable Port Status.
4. Change any options that may be necessary for the port.
5. Save any changes and return to the Data Ports menu.
6. Select Frame Relay.
7. Configure the port to match the DTE’s settings, if necessary.
8. Save the configuration.
Setting Up the Modem
FrameSaver 9126 and 9128 units have an integral modem for remote management.
It is already set up for dial-in access to the unit, with Port Use set to Terminal.
If using the modem for dialed IP network connectivity (SNMP, Telnet, FTP, or trap
dial-out):
1. Select Modem Port.
Configuration
→
Management and Communication
→
Modem Port
2. Minimally, change Port Use to Net Link, Save the change, and return to the
Management and Communication menu.
– Change Port Use to Net Link.
– Assign the IP Address and Subnet Mask if it is different from the Node.
– Change Link Protocol to SLIP, if necessary. The default setting is PPP.
3. Save the configuration.
See
Setting Up the Internal Modem in Setup of the User’s Guide for additional
information.
