Computer telephone number:
(Addresses 008-015)
SECTION 02 - 03
The PC download telephone number is dialed in three situations. It is dialed when communication with
PC is initiated from the keypad. It is the automatic "call back" number, when the "call back" feature is
enabled (086, [4] "on"). If the event buffer is ready to report, and "automatic event buffer transmission"
feature is enabled (088, [2
ND
] "on"), this number will be dialed in order to download the event list.
Related features:
"Panel Identifier" 004 - 005
"PC password" 006-007 "Call back" 086, [4]
Central station telephone number 1
(Addresses 016-023)
SECTION 04 - 05
Central station telephone number 2
(Addresses 024-031)
SECTION 06 - 07
The panel can communicate with two central station numbers. Each of the numbers can be assigned a
separate reporting format.
Related features:
"Communicator Formats" 038
"Reporting options" 086, [11] and [12]
Espload note: Upon alarm, upload/download in progress will be interrupted and the panel will call the central.
System account codes (system "A"/ "B")
(Addresses 032-035)
SECTION 08
All report codes are preceded by a system account code to ensure correct identification of active
zone(s) in a partitioned system. If partitioning is deactivated, the same value should be pro-
grammed for both account numbers. To program account codes for System "A" and "B", press
[
ENTER
] + installer code + [7] + [10] [8]. The first four digits entered after this sequence correspond to
the System "A" account code, and the last four digits to the System "B" account code.
Time Correction
(Address 037, second digit)
SECTION 09
If you notice a gain/loss in panel time, calculate the average
gain or loss per day, and select the “opposite” amount from
the following table to automatically correct the time setting
every 24 hours.
Ex: Panel loses 4 minutes per month.
This represents an average loss of 8 seconds per day.
Select key [2] plus 8 seconds to correct the time setting.
Enter any value for the first digit i.e. [2
ND
] at address 037.
Communicator Formats
(Address 038)
SECTION 09
Ademco contact ID
(all codes reported)
(key [10])
All report codes are preprogrammed in this DTMF reporting format. There is no need to program values for
addresses 300-527 if both central station numbers use this format. Contact ID event codes are listed below:
Ademco contact ID
(programmable codes reported) (key [9])
All addresses from 300 to 527 programmed with values other than [2
ND
] [2
ND
] will report the contact ID
codes corresponding to the values programmed (according to the “Programmable Contact ID Event
Codes” table in the Programming Guide).
Ademco express
(key [8])
This high speed reporting format communicates 2 digit events programmed in addresses 300 to 527 at a
speed of 2 seconds per event.
13
IM738-738EX
