Setup
15
PHYSIO-PORT UP
A9951 Revision C
Before using PHYSIO-PORT UP on a patient
1.
clear the memory
2.
check date and time and adjust if required
3.
select a measurement protocol
4.
enable or disable the audio signal.
Clearing the Memory
The symbol
M
on the display indicates that the
memory holds BP data. If these data still need to be
analyzed, refer to chapter 5 "Data Output" for details
on data evaluation. If you do not need the data any
more, delete it as follows:
Briefly switch PHYSIO-PORT UP off and on
again and wait for the time to be displayed.
Push : the display indicates "H 1".
Push : the display indicates "LLLL"
To delete the data, push again: the display
indicates "0000", followed by the time (if you do
not wish to clear the memory, turn off the BP
monitor instead of pushing ).
Selecting the Measurement Method
Briefly switch PHYSIO-PORT UP off and on
again and wait for the time to be displayed.
Push 9 times: the display indicates "H 9".
Push : the display indicates "0000" if the
selected method is the deflation measurement
method, or "1111" if the selected method is the
inflation measurement method.
Either confirm with or switch to the other
option with , then confirm with .
Note
When using PHYSIO-PORT UP in conjunction with
PhysioPortWin, it is recommended to perform the
first three steps at the PC.
