©
Panduit Corp. 201
4
OPERATION MANUAL
UPS003024024015
Page: 26 of 29
voltage down to the average cell voltage. This will dissipate energy and increase the
charging time. However, the estimated charging time is updated continuously such
that a new charge time will be calculated based on the energy used for cell- balancing.
NOTE: Charge time is only updated during charge mode.
4.7.4. CHARGE LEVEL
The Charge Level represents the percentage charge of the energy storage capacitors
rounded to the nearest percent. This value should be near 100% when fully charged
and near 0% when fully discharged.
4.7.5. HOLD TIME
The Hold Time is estimated based on the energy stored in the capacitors
,
in the
efficiency of energy conversion and the current load power consumption
.
The
estimated hold time is calculated whether the UPS is in the charging or discharging
state and is updated continuously as long as the stack voltage is greater than 5.5V.
Note that if the load power consumption changes, the estimated hold time is updated to
reflect the change in load power.
SETTINGS
4.8.
See note 4.3 for username and password authentication.
4.8.1. MODEL
The Model displays the Model Number of this UPS device (UPS 003 024 024 015).
4.8.2. RESET
The Reset button can be used to restart the UPS in the event of a Minor or Major Fault,
or after a change to Network Settings, or performing a Restore Factory Defaults or
Firmware Update.
A Reset will also impact the following items and must be confirmed using the screen
shown below
:
The Elapsed Time will be reset to zero
The Event Log will be cleared.
