![background image](http://html1.mh-extra.com/html/panasonic/wv-sw390-series/wv-sw390-series_operating-instructions-manual_3543451203.webp)
19.4 Reset the settings/Reboot the camera [Default
reset]
Click the [Default reset] tab of the “Maintenance” page. (
®
page 43, page 45)
The settings and the HTML data of the camera can be initialized and reboot of the camera can be performed
on this page.
[Reset to the default (Except the network settings)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the HTML files to the default.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
[Position refresh]
The camera position can be refreshed. When the camera has moved from the correct home/preset position
during normal use, or when it has been inadvertently moved while turning on the power of the camera, use
this function to correct the camera position.
It is impossible to operate the camera during the position refresh process (for about 2 minutes).
IMPORTANT
•
The direction of the camera may be accidentally changed when the camera is installed. When
registering presets after the installation, we recommend performing position refresh.
Note
•
SW396
:
To initialize the network settings (
®
page 160), turn off the power of the camera, then turn on the power
again while holding down the [INITIAL SET] button on the unit, and keep the [INITIAL SET] button held
down for about 5 seconds. Wait about 6 minutes after releasing the button. The camera will start up
and the settings including the network settings will be initialized. Do not turn off the power of the unit
about 6 minutes just after turning on the power.
Operating Instructions
203
19 Maintenance of the camera [Maintenance]
Содержание WV-SW390 Series
Страница 184: ...5 Click Finish 184 Operating Instructions 17 Configuring the network settings Network ...
Страница 221: ...Operating Instructions 221 Notes ...
Страница 222: ...222 Operating Instructions Notes ...
Страница 223: ...Operating Instructions 223 Notes ...