PROXIMA-TRI
HANECO LED SECURITY LIGHT INSTALLATION GUIDE
For more information
www.haneco.com.au
(08) 8297 6373
Thanks for choosing our PROXIMA-TRI LED Security light
We strongly recommend that you read this manual carefully before installation.
NOTE: Sensor is sold separately, see
product codes on following page.
Sensor Function
•
When the LUX dial is turned to the sun symbol, the light will operate in any light. To have it
operate only when it is dark (less than 10 lux), turn the dial towards the moon symbol.
•
The SENS dial adjusts detection distance. The lowest setting is 2m, which can be increased to
12m by turning the dial towards the + symbol.
•
The time the light remains on can be adjusted from approximately 10 seconds to approximately
7 minutes.
•
Any new movement re-sets the time and delays the moment the light goes off.
The light can stay on for longer time periods by turning the wall switch on and off within one second.
This overrides the sensor and allows the light to remain on when switched on.
To resume sensor mode, switch off, wait 10 seconds and turn the switch back on.
Manual Override Function
Power Source
220-240V a.c. 50Hz
Detection Range
180°
Ambient Light
10-2000LUX (adjustable)
Time Delay
Minimum: 10sec ± 3sec
Maximum: 7min ± 2min
Colour Temperature
5000K
Detection Motion Speed
0.6876 - 1.5m/s
Detection Distance
2 - 12m (adjustable)
Working Temperature
-20 - +40°
Working Humidity
<93% RH
Power Rating
15W per head
IP Rating
IP54
Specifications
Test
When testing in daylight, set the TIME dial to 10S and the LUX dial to the sun symbol.
After 30 seconds the sensor should respond to presence and turn on and then off after the set
10 seconds.
To set the sensor for night time during the day, turn the LUX dial towards the moon symbol and cover
the sensor to simulate darkness.
