Panasonic VARICAM LT, Руководство по эксплуатации

Страница: 62 / 182

– 62 –
Chapter 4 Video Recording and Color Grading — Special recording functions
f
Infrared photography using the IR filter (only IR optical transmittance)
Fig. 1 Fig. 2
1
Remove the lens mount adaptor.
f
For removing of the lens mount, refer to “Replacing the lens mount” (page 30).
2
Remove the three screws securing the IR cut glass, and then remove the IR cut glass. (Fig. 1)
f
Use caution to not drop or lose the IR cut glass or screws to secure the glass.
f
Do not remove the screw behind the IR cut glass. (Fig. 2)
Debris or dust could get inside of the camera.
3
Mount the glass for IR recording, and then secure the glass using securing screws in three areas.
f
The recommended torque when tightening the screws is 0.1 N·m.
4
Attach the lens mount adaptor.
@ @ NOTE
t
Replace the IR cut glass using the opposite procedure when returning to normal recording from IR recording.
t
Replace the IR cut glass and glass for IR recording in a stable location being careful not to drop the glass.
t
Blow the glass clean using a commercially available blower when the glass is covered in debris or dust.
Do not clean the glass using high-pressure air or gas.
t
Wipe the glass gently with a soft, clean cloth when the glass is smudged with water spots or fingerprints.
The glass may warp or the coating may peel when a solvent is used.
Shot mark recording function
Shot mark is the mark added to the thumbnail of each clip to distinguish that clip from others.
Only clips with shot marks attached can be displayed or played back.
Adding shot marks
1
Set [SHOT MARK] in one of [USER1] to [USER3], [USER GRIP1] to [USER GRIP2] in [MENU] → [SYSTEM SETTINGS] → [USER
SWITCHES].
2
During recording or while a clip is selected in the PLAY screen, press the button to which the shot mark is assigned.
f
[MARK ON] is displayed and the shot mark is added to the recorded clip.
f
Another press of the button displays [MARK OFF] and the shot mark disappears.
Text memo recording function
Text memos can be added to any video point.
Adding text memos
1
Set [TEXT MEMO] in one of [USER1] to [USER3], [USER GRIP1] to [USER GRIP2] in [MENU] → [SYSTEM SETTINGS] → [USER
SWITCHES].
2
During a pause or while a clip is selected in the PLAY screen, press the button to which the text memo is assigned.
[TEXT MEMO] is displayed, and the text memo is added to the video clip that was displayed when the button was pressed.
@ @ NOTE
t
Up to 100 text memos can be recorded to a single clip.