Panasonic VARICAM LT, Руководство по эксплуатации

Страница: 58 / 182

– 58 –
Chapter 4 Video Recording and Color Grading — Memory card
@ @ NOTE
t
Do not remove the P2 card after inserting it, while it is being accessed, or being detected (card access LED flashing in orange). Otherwise, it may
result in a malfunction.
t
[TURN POWER OFF] is displayed in the viewfinder screen or the center of the control panel or in the warning message area at the top left of each
output indicator, and a warning is displayed with the warning lamp, etc., when the P2 card being accessed is removed. Also, all card access LEDs
flash rapidly in orange. Turn off the power. (page 170)
t
If the P2 card is removed while being accessed, clips on it may become irregular. Check the clips and restore them, if required.
t
If the P2 card being formatted is removed, formatting of the P2 card is not guaranteed. [TURN POWER OFF] is also displayed in the viewfinder screen
or the center of the control panel or in the warning message area at the top left of each output indicator at this time. Turn off the power and then back
on again, and reformat the P2 card.
To prevent unintentional erasing
To prevent unintentional erasing of the recorded contents in the memory card, move the write protect switch on the memory card to the Protect side (or
the LOCK side).
Write-protect switch Write-protect switch
@ @ NOTE
t
Write-protect switch can be switched while the card is being accessed (during recording or playback), but does not take effect until accessing of the
card stops.
Status of card access LED and P2 card
Card access LED P2 card status
Illuminated in orange Recording target Reading/writing are both possible.
Flashing in orange Accessing card Reading/writing are currently being performed.
Flashing in orange rapidly The card is being recognized. The P2 card is being recognized.
Flashing in green slowly
Card full There is no free space on the P2 card. Reading only is possible.
Write protect
The write-protect switch on the P2 card is at the Protect position. Reading
only is possible.
Unrecordable card
It cannot record with the recording format that is currently set. To record,
change the recording format or use the card that can record.
Card not supported This card cannot be used on the camera. Replace the card.
Off*
Illegal format The P2 card is not properly formatted. Reformat the card.
No card The P2 card is not inserted. The card is waiting to be recognized.
Unauthenticated card
This is a P2 card that cannot be authenticated.
Unlock with the device the password was set if the CPS password is set.
* [ERR] is displayed on the HOME screen. Confirm the content in the INFO screen.
Status of card access LED and SD memory card
Card access LED SD memory card status
Illuminated in orange Recording target Reading/writing are both possible.
Flashing in orange Accessing card Reading/writing are currently being performed.
Flashing in orange rapidly The card is being recognized. The SD memory card is being recognized.
Flashing in green slowly Accessing card
Reading files from the SD memory card or writing files to the SD memory
card.
(Scene files/setup files/CDL/3D LUT/update files)
Off*
Card full There is no free space on the SD memory card. Reading only is possible.
Write protect
The write-protect switch on the SD memory card is at the Protect position.
Reading only is possible.
Unrecordable card
It cannot record with the recording format that is currently set. To record,
change the recording format or use the card that can record.
Card not supported This card cannot be used on the camera. Replace the card.
Illegal format The SD memory card is not properly formatted. Reformat the card.
No card
The SD memory card is not inserted. The card is waiting to be
recognized.
Unauthenticated card This is a SD memory card that cannot be authenticated.