INT
R
O
11
RQT
7
0
6
2
2
Press the speaker cable into the groove.
∫
Preventing the speakers from falling over
Preparation
Attach screw eyes (not supplied) to secure the speakers to a wall
(
➜
diagram on the right).
≥
You will need to obtain the appropriate screws to match the walls and
pillars to which the screw eyes are going to be fastened.
≥
Consult with a qualified housing contractor concerning the appropriate
procedure when attaching to a concrete wall or a surface that may not
have strong enough support. Improper attachment may result in damage
to the wall or speakers.
1
Thread the string (not supplied) through the slot on the rear of
the front speaker to prevent it from falling over.
2
Loop the string through the screw eye and tie tightly.
String (not supplied)
Approx. 150 mm
r
:Copper
s
:Silver
Be careful not to loosen the screw too much
or the front speaker may detach and fall.
Wall
3
Adjust the speaker height.
≥
Check the screws you tightened in procedures 1 and 2 if the pipe and
speaker are loose.
1
Loosen the attached speaker mounting
plate screw until the attached speaker is
slightly loose and adjustable.
2
With one hand on the base, and the other
holding the speaker adjust the height of
the speaker up and down.
≥
After adjusting the height tighten the screw on
the mounting plate securely.
4
Connect the speaker cables.
Push !
1
Press the speaker cable and
thread between the hooks.
Cable
Screw eye (not supplied)
Rear of the front speaker
Rear speaker panel
Stopper screw
Screw to stop mounting plate from moving or sliding
below this point.
Rear side of base
If there is any excess
speaker cable, thread
the speaker cable from
the opening near the top
of the pipe while pulling
the speaker cable from
the bottom of the base.
Phillips-head screwdriver
5
Fasten the speaker cable to the base.
≥
Using the same polyfoam as done in procedure 2 will assist you in safely securely fastening the speaker cables.
2
Fit the speaker cable into the base
cover groove as far as possible.
1
Connect the speaker cables.
≥
Twist off the vinyl ends of the speaker
cables.
e.g., Attaching the stand to the lower rear of the front speaker
e.g.
7062en.book 11 ページ ２００３年８月２７日 水曜日 午後２時５６分
