34
Available commands are listed below.
I
Set/edit the IP address.
Press "I." The command prompt changes to "Enter IP address>." Enter the IP address for the
Switching Hub.
M
Set/edit the subnet mask.
Press "M." The command prompt changes to "Enter subnet mask>." Enter the subnet mask
for the Switching Hub.
G
Set/edit the IP address of the router for the default gateway.
Press "G." The command prompt changes to "Enter new gateway IP address>." Enter the IP
address of the router, set as the default gateway.
A
Set the IP address, subnet mask and default gateway in succession.
1. Press "A." The command prompt changes to "Enter IP address>." Enter the IP address of
the Switching Hub.
2. Then, the command prompt changes to "Enter subnet mask>." Enter the subnet mask.
3. Then, the command prompt changes to "Enter new gateway IP address>." Enter the IP
address of a router, used as a default gateway.
Q
Return to the parent menu.
Note:
Unless you configure these settings, you cannot use remotely connect to the
Switching Hub via Telnet or WEB. Be sure to configure. All IP addresses on the
local network must be unique, and no duplications are allowed. If you are
unsure, consult the network administrator.
