1
1-314
Checking indoor unit addresses
Use the remote controller to check the addresses of the indoor units.
Indicating (marking) the indoor and outdoor unit combination number
Indicate (mark) the number after automatic address setting is completed.
Press and hold the
(simple settings mode, “ALL” appears on the remote controller).
Then press the
The indoor unit fan operates only at the selected indoor unit.
Confirm the indoor unit address. (For the system addresses of the
No. 2 outdoor unit, the displayed addresses are 2-1, 2-2)
(For the system addresses of the No. 1 outdoor unit, each time the
button is pressed, the address changes as follows: 1-1, 1-2)
button and select the indoor address.
button and
button for 4 seconds or longer
So that the combination of each indoor unit can be easily checked when multiple units are installed, ensure that
the indoor and outdoor unit numbers correspond to the system address number on the outdoor unit control PCB,
and use a magic marker or similar means which cannot be easily removed to indicate the numbers in an easily
visible location on the indoor units (near the indoor unit nameplates).
Example: (Outdoor) 1 – (Indoor) 1, 2
(Outdoor) 2 – (Indoor) 1, 2
(1)
These numbers will be needed for maintenance.
Be sure to indicate them.
(2)
Press the
button again to return to the normal remote controller mode.
SM830231-02̲Single̲欧州.indb 314
SM830231-02̲Single̲欧州.indb 314
2014/09/19 13:21:50
2014/09/19 13:21:50
