1
1-309
Test Run Procedure
YES
YES
YES
NO
NO
NO
Recheck the items to check before the test run.
Check the combination (wiring) of indoor and outdoor units.
See section “Basic wiring diagram”
for Type U1, T2, F1, N1 and Y2
(for Link Wiring).
See section “Items to Check Before the
Test Run” for Type U1, T2, F1, N1 and
Y2 (for Link Wiring).
Is system “single-type”?
Is outdoor unit multiple?
Set the outdoor unit system address.
Set the remote controller to “test run”.
See section “Test Run Using the Remote
Controller” for Type U1, T2, F1, N1 and Y2
(for Link Wiring).
See section “Table of Self-Diagnostic Functions
and Corrections (Type U1, T2, F1, N1 and Y2)”
Can operation
be started?
Return the remote controller
to normal control.
Turn ON the indoor
and outdoor power.
Automatic Address Setting
Turn ON the indoor and outdoor power. (Automatic Address Setting)
Refer to “Table of Self-Diagnostic
Functions” to check the system.
In addition, refer to section “Automatic
Address Setting” for Type U1, T2, F1, N1
and Y2 (for Link Wiring) and correct any
items that need to be corrected.
Note: Check the indoor side drainage.
(*)
(*) Indicate (mark) the combination number.
(See section “Checking indoor unit addresses” and “Indicating (marking) the indoor
and outdoor unit combination number” for Type U1, T2, F1, N1 and Y2 (for Link Wiring).)
Required for simultaneous-operation
multi systems and for group control.
Set the automatic address setting from
outside unit or remote controller.
(See section “Setting outdoor unit system addresses”
for Type U1, T2, F1, N1 and Y2 (for Link Wiring).)
How to Set the Outdoor Unit System Address
(See section “Basic wiring diagram”
for Type U1, T2, F1, N1 and Y2 (for Link Wiring).)
How to Set Automatic Address
SM830231-02̲Single̲欧州.indb 309
SM830231-02̲Single̲欧州.indb 309
2014/09/19 13:21:49
2014/09/19 13:21:49
