Panasonic PT-RCQ10, Руководство по эксплуатации, Страница: 40 / 267

Chapter 2 Getting Started — Setting up
40 - ENGLISH
Parts for installation (optional)
The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:
ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings), ET-PKD130H (for High Ceilings, 6-axis
Adjustment)) and the Ceiling Mount Bracket (Model No.: ET-PKD130B (Projector Mount Bracket)).
f
Be sure to use the Ceiling Mount Bracket specified for this projector.
f
Refer to the Installation Instructions of the Ceiling Mount Bracket when installing and setting up the projector.
Attention
f
To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualified
technician.
Interface Board (optional)
This projector is equipped with one SLOT NX-specification slot.
There are one HDMI input terminal, one DVI-D input terminal, one SDI input terminal, and one DIGITAL LINK
terminal equipped on this projector as the standard video input terminals. The input for HDMI, DVI-D, and SDI can
be added by installing the optional Interface Board in the slot.
Attention
f
Requesting a qualified technician to install or remove the optional Interface Board is recommended. A malfunction may occur due to static
electricity. Consult your dealer.
Projected image and throw distance
Install the projector referring to the projected image size and projection distance. Image size and image position
can be adjusted in accordance with the screen size and screen position. The projection relation between the
screen and the projector differs from that of other lenses, when the Fixed-focus Lens (Model No.: ET-DLE035) is
used. Refer to “Fixed-focus Lens (Model No.: ET-DLE035)” (
x
page 41) for details.
Attention
f
Before setting up, read “Precautions for use” (
x
page 20).
Especially when the Fixed-focus Lens (Model No.: ET-DLE035) is used, install the projector so that its back plane is parallel to the screen,
making the projected image rectangular.
The vertical keystone distortion in moderate range can be corrected with the [POSITION] menu → [GEOMETRY] → [KEYSTONE] →
[VERTICAL KEYSTONE] (
x
page 103) even after the projector is installed. For the range that can be corrected, refer to “[GEOMETRY]
projection range” (
x
page 42).
f
Do not use the projector and the high-powered laser equipment in the same room. The DLP chips can be damaged if a laser beam hits the
projection lens surface.
Note
f
The optional Zoom Lens (Model No.: ET-DLE170) is equivalent to the lens attached to the projector models with standard zoom lens.
The availability of this product varies depending on the country. For details, contact your dealer.
Figure of projected image and throw distance
SD
L (LW/LT)
L1
L1
L (LW/LT)
SW
SH
H
SH
SW
Projected image
Screen
Screen
Note
f
This illustration is prepared on the assumption that the projected image size and position have been aligned to fit full in the screen.
SH Projected image height
SW Projected image width