Panasonic PT-RCQ10, Руководство по эксплуатации, Страница: 263 / 267

Chapter 7 Appendix — Installing the Interface Board (optional)
ENGLISH - 263
Installing the Interface Board (optional)
This projector is equipped with one SLOT NX-specification slot.
There are one HDMI input terminal, one DVI-D input terminal, one SDI input terminal, and one DIGITAL LINK
terminal equipped on this projector as the standard video input terminals. The input for HDMI, DVI-D, and SDI can
be added by installing the optional Interface Board in the slot.
Requesting a qualified technician to install or remove the optional Interface Board is recommended. A malfunction
may occur due to static electricity. Consult your dealer.
Before installing or removing
f
Always turn off the power of the projector before installing or removing the Interface Board.
g
Always follow the procedure of “Switching off the projector” (
x
page 74) when turning off the power.
f
Do not touch the connector section of the Interface Board directly with your hands.
g
The component may be damaged by the static electricity.
f
Remove the static electricity from your body by touching to surrounding metal, etc., in advance to prevent the
static electricity damage.
f
Take care not to get injured when installing or removing the Interface Board.
g
Hands may be injured by the opening of the blank slot or the edge of the bracket of the Interface Board.
f
When installing the Interface Board to the slot, insert it into the connector straight and slowly.
g
It may not operate or cause malfunction if it is not correctly installed.
f
The figure indicating the installation and removal of the Interface Board is using the Interface Board for 12G-SDI
(Model No.: ET-MDN12G10) as an example.
How to install the Interface Board
Screws (4 locations) Screws (4 locations)
Salient
Guide groove
Slot cover
Fig. 1 Fig. 2 Fig. 3
1) Remove the slot cover. (Fig. 1)
f
Remove the four screws fixing the slot cover by rotating counterclockwise with a Phillips screwdriver. The
removed screws are used to fix the Interface Board.
f
When removing the fourth screw, hold the slot cover with your hand so it will not fall.
f
To replace from other Interface Board, remove the Interface Board following the procedure in “How to
remove the Interface Board” (
x
page 264).
2) Install the Interface Board to the projector. (Fig. 2)
f
Insert the guide groove of the Interface Board aligned to the salient of the slot. Insert the bracket firmly all
the way in.
3) Fix the Interface Board. (Fig. 3)
f
Tighten and fix with the four screws removed in Step
1)
.
Attention
f
The removed slot cover is required when the unnecessary Interface Board is removed. Store it so it can be attached in the future.