Panasonic PN261693D, Руководство пользователя, Страница: 88 / 195

88
4.2.4. Set Port Priority
Press G (command) on Trunk Configuration Menu, and then you can see “LACP
Status” as Figure 4-11. You can check the status of LACP group on this screen.
(The status can be displayed for the key whose mode is either Active or Passive.)
Figure 4-11: Set Port Priority
Screen Description
The following describes how to use several commands on this screen.
System Priority This is the priority of this device, which is necessary for configuring the trunking
on the network using the LACP. The lower a numeric value is, the higher the pri
-
ority will be. The factory default settings is one.
System ID This is an ID of this device, which is necessary for configuring the trunking on the
network with the LACP. The MAC address of this device becomes the ID, and is
not changeable. The combination of the system priority (value) and the system ID
becomes the system ID on the LACP.
Key Displays the group number for trunking.
Aggregator This is the number for the logical interface of trunking. The aggregator becomes
the same with the port-number with the highest value of port priority among
ports configuring the trunking.
Attached Port
List This is the number for the physical interface (ports) connected to the logical inter
-
face (aggregator). If the trunking group, which exceeds nine ports, is configured,
the port with the lower value of the port priority becomes the backup mode to
display the standby.
Standby Port List If the trunking group, which exceeds nine ports, is configured, the port with the
lower value of the port priority becomes the back up mode. This field (or column)
displays the appropriate ports.
Q Returns to the top menu.
PNxxxxxx Local Management System
Trunk Configuration Menu -> Set Port Priority
System Priority : 32768
System ID : xx:xx:xx:xx:xx:xx
Group ID : 1
Aggregator Attached Port List Standby Port List
---------- -------------------------------- --------------------------------
1 1
-------------------------------- <COMMAND> -----------------------------------
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option