The Maintenance mode main menu will be displayed.
Site Survey for S-PS Service Area
1.
Place a SIP-CS in the location confirmed for the Air Sync Master CS in the previous site survey.
2.
Supply power to the SIP-CS.
3.
Perform the next step according to the registration state of the S-PS, as follows:
•
If the S-PS is unregistered, press
.
•
If the S-PS is registered, start the S-PS in Maintenance mode.
(For more information, see "Starting the S-PS in Maintenance Mode" above.)
Select "
CS Area Check
" on the S-PS, and then press
.
4.
Press
.
The S-PS will be in CS Area Check mode and you will hear a tone.
5.
Walk around the SIP-CS to confirm the SIP-CS’s service area.
If the radio strength level and Error Rate are at acceptable levels, you will continue hearing a tone from
the S-PS and 2 lines on the LCD of the S-PS light green.
Note
If there is an area where you cannot hear a tone and the 2 lines of the LCD do not light green, relocate
the SIP-CS.
6.
After confirming the service area, press POWER/CANCEL key on the S-PS to stop the tone.
7.
Relocate the SIP-CS to another location.
8.
Walk around the SIP-CS to confirm the SIP-CS’s service area.
9.
for all the locations so that the SIP-CSs will provide service for whole area.
Radio Signal Strength Level
RSSI
Quality
13 to 17
Very Good
8 to 12
Good
4 to 7
May receive noise
Under 3
May receive noise easily or become disconnected.
Error Rate Level
Error Rate Level
Quality
0 %
Better
2 %
Good
3 %
May receive noise
10 %
May fail to make/receive calls
38
Installation Guide
4 Deployment Procedure
