5. Outline of Key Operation and Each Mode
5.1 Key Operation
Setting item numbers such as [1], [9] are the same as those on Section “14. Key Operation Flowchart”
(p.131).
Power ON
+
+
+
(3 sec)
Data clear
Yes/No
Starts from
previous
status (last
shutdown).
RUN mode
By pressing
for 1 sec, one item below selected in [OUT/OFF key function] is indicated.
Program Control
Control output OFF
Auto/Manual Control
PV/SV display
(1 sec)
Program control
Control output
Manual control
(*1)
RUN
OFF
+
(3 sec)
+
+
(3 sec)
Initial Setting Mode
Main Setting Mode
Sub Setting Mode
Engineering Mode 1
Input type
SV1
AT/Auto-reset
Set value lock
Perform/Cancel
[1]
[10]
[37]
[62]
SV4
Step 9 wait
Loop break
Controller/
value
alarm span
Converter
[9]
[36]
[61]
[89]
(3 sec) (*2)
+
+
(5 sec)
Monitor Mode
Engineering Mode 2
MV indication
Control method
[90]
Remaining time
(*3)
Integral 2DOF
Current step
coefficient (
β
)
number (KT4R)
[92]
(*3)
(*1) If ‘Program control’ is selected in [OUT/OFF key function], the unit enters Standby mode (program control waiting).
(*2) The unit cannot proceed to Monitor mode if it is in Standby of program control.
(*3) Available only when ‘Program control’ is selected in [OUT/OFF key function].
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]