Panasonic FZ-M1 Series, Инструкция по эксплуатации - Справочное руководство

Страница: 79 / 147

Danish
Norwegian
Hungarian
Dutch (Netherlands)
IBM/NCR Terminals
Setting the USB Mode
Use in the [USB HID Keyboard] mode normally. If the barcode cannot be read with this mode, the application may be compatible with [USB HID POS]. In
this case, change the mode according to the following steps.
1. Touch (Panasonic PC Settings Utility) - (Utilities) - [Barcode HID Mode Setting].
2. When using POS API: Touch and add a check mark for [USB HID POS], and then touch [OK].
When not using POS API: Touch and add a check mark for [USB HID Keyboard], and then touch [OK].
Reading the Barcode
C A U TI O N
n
Do not look directly into the reading window.
DO NOT LOOK DIRECTLY AT THE BARCODE READER LIGHT.
[2D Barcode Key Emulator] enables:
it makes sound when reading barcode is successful.
it reads barcode with 2 bytes code.
1. Touch (Panasonic PC Settings Utility) - (Utilities) - [2D Barcode Key Emulator].
2. Touch [Connection to Barcode (Always-On)].
3. Open the software for reading a barcode, and put the cursor on it.
4. Aim the Barcode Reader (A) at the barcode.
5. Press button (B).
The Barcode Reader lights red to indicate the reading position.
C A U TI O N
n
COM Port of Barcode Module is occupied during reading barcode by Barcode Key Emulator. When reading barcode by Barcode Key
Emulator is not necessary, touch [Connection to Barcode (Always-On)] in [2D Barcode Key Emulator].
N O T E
n
When the barcode read operation is finished, please wait about three seconds to start the next reading. You may press the button imme-
diately, even if you set to release, it takes several seconds to light to light actually.
n
<only when [Concealed Mode] is set [Disabled]>
Set [A Button] to [Barcode Reader Trigger] in the [Tablet Button Configuration] of [Main] menu of the Setup Utility.
- 79 -