Panasonic FZ-M1 Series, Инструкция по эксплуатации - Справочное руководство

Страница: 31 / 147

n
To cancel the battery recalibration, press power switch
n
The temperature range should be 10°C to 30°C {50°F to 86°F}.
n
Frequent recalibration of the battery can degrade the battery. A caution message appears when the battery recalibration is performed
at the shorter interval than approximately a month. In this case, cancel the battery recalibration.
n
If the computer is turned off during the battery recalibration (e.g., due to power failure, or accidental removal of the AC adaptor and bat-
tery pack), the battery recalibration will not be completed.
n
The battery recalibration may take a long time due to the large battery capacity. This is not a malfunction. (An expected approximate
recalibration time is displayed.)
n
<Only for model with Built-in Bridge Battery>
The battery recalibration cannot be performed for the built-in bridge battery.
Replacing the Battery Pack
The battery pack is a consumable item so the replacement will be necessary. If the battery operation time becomes noticeably short and not recovered
even after recalibrating the battery, replace with a new battery.
C A U TI O N
n
The battery pack is not charged when you first purchase it. Be sure to charge it before using for the first time. Charging starts auto-
matically when the AC adaptor is connected to the computer.
n
Use only the specified battery pack with your computer.
n
Make sure no foreign objects are under the computer.
n
In sleep, do not remove/replace the battery pack. Otherwise your data will be lost and the computer may be damaged.
n
Do not use without inserting battery pack.
n
If the computer is wet, wipe them off and open the cover. Make sure to dry off the computer, replace/remove the battery pack.
N O T E
n
<Only for model with Built-in Bridge Battery>
If the built-in bridge battery has enough remaining power, you can replace the battery pack without turning off the computer (Hot swap)
and during sleeping the computer (Warm swap).
1. Turn off the computer.
Do not use the sleep function.
2. Turn your computer over and remove/insert the battery pack.
Make sure no foreign objects are under the computer.
To remove
Push and slide the latch to the unlocked position, and raise the battery pack.
<Only for model with Built-in Bridge Battery>
Confirm that the battery indicator on the rear of the computer lights green; this means that the built-in bridge battery has enough remain-
ing power required for a hot swap.
When the battery indicator on the rear of the computer doesn't light; Shutdown, Hibernation and while the AC adaptor is connected to
the computer.
C A U TI O N
n
In the case of a hot swap, finish replacing the battery within a minute. Depending on the built-in bridge battery status, the com-
puter may enter hibernation within one minute. Replace the battery pack as soon as possible.
n
If you start a hot swap with the AC adaptor connected, do not disconnect the AC adaptor until the battery pack has been
replaced. If you unplug the AC adaptor ,even if Built-in Bridge Battery is charged, the computer will turn off.
- 31 -