Panasonic EB-GD52, Руководство по обслуживанию

Страница: 23 / 92

DISASSEMBLY / REASSEMBLY INSTRUCTIONS
MCUK000601C8 Section 4 Issue 1
Service Manual – 19 – Revision 0
4 DISASSEMBLY / REASSEMBLY INSTRUCTIONS
4.1. General
This section provides disassembly and reassembly procedures for the main components of GD52, GD92 and GD92C
telephones.
These assemblies MUST be performed by qualified service personnel at an authorised service centre.
The following Warnings and Cautions MUST be observed during all disassembly / reassembly operations:
4.1.1. ESD Handling Precautions
A working area where ESDs may be handled safely without undue risk of damage from electrostatic discharge , must be
available. The area must be equipped as follows:
Working Surfaces
All working surfaces must have a dissipative bench mat, safe for use with live equipment, connected via 1M2 resistor
(usually built into the lead) to a common ground point.
Wrist Strap
A quick release skin contact device with a flexible cord, which has an integral safety resistor of between 5k2 and 1M2, shall
be used.
Containers
All containers and storage must be of the conductive type.
4.2. Disassembly
4.2.1 Case Removal (GD52)
1. Remove the battery cover by pushing it towards the base of the phone and then lifting it away from the case.
Figure 4.1: GD52 Battery Cover Removal
2. Slide the battery lock to the ‘release’ position, and lift the battery from the case.
WARNING
The equipment described in this manual contains polarised capacitors uitilising liquid electrolyte. These devices are entirely safe provided
that neither a short-circuit nor a reverse polarity connection is made across the capacitor terminals. FAILURE TO OBSERVE THIS WARN-
ING COULD RESULT IN DAMAGE TO THE EQUIPMENT OR, AT WORST, POSSIBLE INJURY TO PERSONNEL RESULTING FROM
ELECTRIC SHOCK OR THE AFFECTED CAPACITOR EXPLODING. EXTREME CARE MUST BE EXERCISED AT ALL TIMES WHEN
HANDLING THESE DEVICES.
Caution
The equipment described in this manual contains electrostatic devices (ESDs). Damage can occur to these devices if the appropriate han-
dling procedure is not adhered to.
1
2
3
10233-1