Panasonic EB-GD52, Руководство по обслуживанию

Страница: 35 / 92

TEST AND MEASUREMENT
MCUK000601C8 Section 6 Issue 1
Service Manual – 31 – Revision 0
6 TEST AND MEASUREMENT
6.1. Introduction
This section provides information on testing GD52, GD92 and GD92C telephones. The layout is as follows
1. Section 6.2 ALIVH PCBs: Description and repair procedures.
2. Section 6.3 External testing: describes equipment requirements and general set up procedure.
3. Section 6.4 Complete Unit Test Setup: describes how the items of test equipment are used together and general set up
procedure.
4. Section 6.5 Channel box test commands: provides detailed explanation of the different commands available using the test
equipment and channel-box software.
5. Section 6.6 Adjustment mode: describes adjustments available on the handheld unit.
6.2. Any-Layer Interstitial Via Hole (ALIVH) PCBs
6.2.1. General Information
To reduce overall size and provide enhanced speech and data performance, an Any-Layer Interstitial Via Hole (ALIVH) PCB
is used in GD52, GD92 and GD92C handsets. ALIVH PCBs are multi-layer boards which have an IVH structure in all inter-
layers and can provide an inter-layer connection immediately under the land of a component. In addition, the PCB has no
through holes and any number of layers can be interconnected.
As the specification and performance characteristics of ALIVH PCBs differ from that of conventional multi-layered boards,
special attention is required when handling and repairing these assemblies.
Moisture Absorbency
The ALIVH PWB is more absorbent than a conventional PCB because of the nature of its material. Its aramid substrate is
hydrophilic, i.e. it absorbs moisture from the air. If, after having absorbed moisture, the ALIVH PWB is submitted to re-flow or
repair process, moisture in the board can suddenly evaporate and cause vapour explosion.
Copper Foil Peel Strength (Land Detachment Resistance)
The ALIVH PCB is slightly less resistant to copper detachment force than conventional boards. Therefore, it is necessary to
ensure that solder is melted sufficiently before a component is removed from the board.
Warping Property
The ALIVH PCB has a smaller Young's Modulus and is therefore more pliant than conventional boards. It is important that the
ALVIH PCB is not bent when component placement is performed.
6.2.2. Repair Procedures
To prevent problems caused by moisture absorption, it will be necessary to perform dehydration of ALIVH PCBs in a suitable
oven or similar heating device prior to repair. The boards should be heated at 85 °C for a duration of at least ten hours.
The repair should also be performed under the following conditions:
6.2.2.1. Soldering Iron
The temperature of the tip of the soldering iron should be 350 °C ±10 °C for an application time of five seconds or less.
Removal and re-mounting of components should be performed only once at any component position.
Note: To avoid land detachment, do NOT apply excessive force on the soldering iron when heating the board.
Ensure that the solder has melted sufficiently to allow component removal without damaging the board.
CAUTION
The GD52, GD92 and GD92C telephone handsets use an ALIVH PCB assembly, the substrate of which is hydrophilic. To
avoid damaging the ALIVH PCB, the specialist equipment and procedures described below must be employed when
replacing suspect or faulty components.