Extension does not operate. Bad connection between
Take that extension and plug it into the same
system and extension
extension port using a short telephone cord.
If telephone does not work, connection between the
system and the extension must be repaired.
The system program switch
Set to SET except when programming.
of the KX-
T308I 0
is set to
PROGRAM.
A telephone with an A -AI
Use a
2
wires cord.
relay is connected.
Set the A -AI relay switch of the telephone to
OUT or OFF.
Bad extension
Take that extension and plug it into another
extension port that is working. If the telephone
does not work, replace the phone.
Improper reset operation
Press the Reset Button.
Call is disconnected during
Instantaneous drop of DC
Program for a no CPC signal ( CPC means
connection operation.
voltage from Central Office
Calling Party Control)
(or host PBX) when in
Set the calling party control signal to
operation of connection
"DISABLE".
between C.
0.
and system.
Refer to page
2-28.
Noise in external paging
Induced noise on the wire
Use a shielded cable as a connection wire between
between System and an
System and Amplifier.
Amplifier.
A shorter shielded cable is recommended.
I
Volume distortion from
Excessive input level from
mcrease the Output level of the external music
external music source
external music source
source by using the Volume Control on the
music source.
Speed dialing or One Touch Bad programming
Enter the line access code (9,
81, 82, 83)
into
Dialing does not function.
programming.
A dial tone (short tone
The host PBX may cause
Use the handset instead of the speakerphone.
continuously) was heard
the line to hang up when the
and telephone line hung up
KX-
T308I 0
was connected
at once when accessing a
to it.
outside during the
speakerphone mode.
5-/
