Panasonic DP-8020E, Руководство по обслуживанию

Страница: 318 / 498

318
SEP 2006
Ver. 1.0
DP-8020E/8020P/8016P
7 Installation
7.1. Set Up Precautions
Before you begin the installation, read these entire instructions. You must locate an appropriate site (firm
and leveled surface) for the installation. Reading this section assists you with the decision making process.
Machine performance, and copy quality is subject to, and dependant on environmental conditions.
To maintain good performance, quality, and safe operation, observe the following precautions:
1. For safe operation and to avoid trouble, do not install the system under the following conditions:
• Extremely high or low temperature and humidity.
Ambient conditions Temperature : 50 - 86
°
F (10 - 30
°
C)
Relative humidity : 30 - 80 %
• Sudden changes in temperature or humidity
• Exposed to direct sunlight
• Dusty environment
• Poorly ventilated location
• Exposed to chemical gases (such as ammonia gas)
• Exposed to strong vibration
• Exposed to direct air current (ex: Air conditioner vent)
2. The weight of the machine (options not included) is as follows:
DP-8020E / 8020P / 8016P : Approx. 93.26 - 98.33 lb (42.3 - 44.6 k
g
)
Options:
DA-AS202 / DS181 (iADF / ADF) : Approx. 20.5 lb (9.3 k
g
) / 11.0 lb (5.0 k
g
)
DA-DS185 / DS184 (Paper Tray) : Approx. 20.7 lb (9.4 k
g
) / 19.8 lb (9.0 k
g
)
3. The maximum power consumption is 1.3 kW. Depending on the product destination, the wall outlet
must be rated for 120 VAC / 15 Amps, or 220-240 VAC / 10 Amps accordingly. If you have doubts
regarding a power source, ensure that a qualified electrician checks the outlet. Do not connect any
other devices to the wall outlet designated for this machine. (Do not use an extension cord)
4. Make sure the outlet is properly grounded. (Do not ground to gas, or water pipe)
5. The machine should be installed in a well-ventilated area to minimize the ozone density in the air.
6. This machine has ventilation openings on the side, and rear, which must remain unobstructed for safe
operation. The machine should be located at least 3.94 inches (100 mm) from the wall. Obstructing the
ventilation openings could present a fire hazard.
Using the space requirements shown on the following page, ensures that the machine has the ventilation it
requires, and that you have the space needed for replacing the supplies.