Panasonic DLP PT-FRZ50, Инструкция по эксплуатации (Функциональное руководство)

Страница: 102 / 189

Chapter 4 Settings — [PROJECTOR SETUP] menu
102 - ENGLISH
g
Are there devices with the same IP address on the network?
g
Are LAN cables connected correctly? (
x
page 131)
g
Are the subnets of the projectors the same?
g
Are the same [LINK] settings applied to a group?
f
Refer to [PROJECTOR NAME] (
x
page 122) or “[Network config] page” (
x
page 140) on how to change the projector name.
Brightness control adjustment procedure example
The steps exemplify an adjustment to link the brightness of eight projectors connected in a network.
1) Connect all projectors to the switching hub using LAN cables. (
x
page 131)
2) Switch on all projectors and start projection.
3)
Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [OFF], and select [APPLY], and then
press the <ENTER> button.
4) Set [OPERATING MODE] of each projector to the same setting. (
x
page 95)
5) Set [SUBNET MASK] and [IP ADDRESS] in each projector.
f
To be able to communicate over the network, set the same value in [SUBNET MASK] for all projectors and
set a different value in [IP ADDRESS] for each projector.
6) Wait for at least eight minutes after projection has started until the light source brightness becomes
steady.
7) Set all items in the [PICTURE] menu of all projectors to the same values.
8) Adjust [COLOR MATCHING] to match colors.
9) Display the internal test pattern “All white” in all projectors.
10) Set [BRIGHTNESS CONTROL GAIN] of all the projectors to 100 %.
11) Set [BRIGHTNESS CONTROL GAIN] of the projector with the least brightness to 90 %.
12) Adjust [BRIGHTNESS CONTROL GAIN] of each projector.
f
Adjust [BRIGHTNESS CONTROL GAIN] of all the other projectors so that the brightness will be the same
as the projector with the least brightness.
13) Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [AUTO], and [LINK] to [GROUP A] in
all projectors.
14) Select [APPLY] of [BRIGHTNESS CONTROL SETUP] and press the <ENTER> button in all projectors.
f
Brightness control starts.
Note
f
Brightness is automatically corrected whenever the light source lights up by switching on/off the projector, etc.
f
When the variation in brightness has increased due to aging of the light source, or when you replaced the light source, readjust the
brightness control.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1) Press
as
to select [SCHEDULE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (
x
page 103) or “How to set a
program” (
x
page 103) for how to set the schedule.