Panasonic CZ-256ESMC2, Руководство по эксплуатации

Страница: 98 / 104

96
Supplied parts
Part
number
Part
number
e m a n t r a P e m a n t r a P y t i t n a u Q y t i t n a u Q
Small
pan head
bolt
(M4 x 10)
Operation
Manual
4 Nut (M4) 4
1
1
5
2
Flat
washer
4
6
Cable tie
4 3
Specifications
Rated voltage ·················· 100 - 240 V ~, single phase
Rated frequency ············· 50/60 Hz
Power consumption ········ 30 W max.
Operating temperature ··· 5° to 40° C
Operating humidity ·········· 20 to 80%
(non-condensing)
16 Installation (Electric) and Service Instructions
Safety Precautions
Before conducting installation or electrical work, be sure to carefully read these “Safety Precautions” and follow them carefully.
The precautions given in this manual consist of specific “Warnings” and “Cautions”. Be sure to follow these precautions, as they provide
important safety related information. The labels and their meanings are as described below.
This refers to a hazard or unsafe procedure or practice which can result in severe personal injury or death.
This refers to a hazard or unsafe procedure or practice which can result in personal injury or product or
property damage.
Warning
Be sure to arrange installation at the dealer where the system was purchased or use a professional installer. Electric shock or fire may
result if an inexperienced person performs any installation or wiring procedures incorrectly.
Carefully follow these Installation (Electric) and Service Instructions when installing the unit. Electric shock or fire may result if the unit is
not installed correctly.
Electrical installation should be performed by qualified electrician, in accordance with the provisions of the Technical Standards for
Electrical Installations, local regulations for indoor wiring, and these Installation (Electric) and Service Instructions. Be sure to use a
dedicated electrical circuit. Insufficient electrical circuit capacity may result in electric shock or fire.
Use the specified cables for the electrical connections, and connect the cables securely. Fasten the cables securely so that the cables
will not exert force on the connection terminals. Insecure connections or fastening may result in overheating or fire.
The installation location requires the use of a circuit breaker. Failure to use a circuit breaker may result in electric shock or fire.
Caution
When performing electrical installation, discharge any accumulated static electricity to ground before touching the unit.
Warning
Caution
Circuit breaker must be incorporated in the fixed wiring in accordance with the wiring regulations. The circuit breaker must be an approved
10-16 A, having a contact separation in all poles.
1
Cautions regarding the design of the control box
Control box machining diagram
External dimensions
242 mm (board opening width)
bolt hole diameter: 5 mm
bolt hole diameter: 5 mm
255 mm (bolt hole pitch)
224 mm (board opening height)
218 m
m
(bolt hole pitch)
238
280
220 220 240
118
20
CZ-256ESMC2_EN.indb 96 CZ-256ESMC2_EN.indb 96 9/14/2011 3:17:22 PM 9/14/2011 3:17:22 PM