Panasonic CS-MRE7PKE, Руководство по обслуживанию

Страница: 29 / 110

29
12. Installation Instruction
12.1 Select the Best Location
12.1.1 Indoor Unit
š
Do not install the unit in excessive oil fume area
such as kitchen, workshop and etc.
š
There should not be any heat source or steam
near the unit.
š
There should not be any obstacles blocking the air
circulation.
š
A place where air circulation in the room is good.
š
A place where drainage can be easily done.
š
A place where noise prevention is taken into
consideration.
š
Do not install the unit near the door way.
š
Ensure the spaces indicated by arrows from the
wall, ceiling, fence or other obstacles.
š
Recommended installation height for indoor unit
shall be at least 2.5 m.
12.1.2 Outdoor Unit
š
If an awning is built over the unit to prevent direct
sunlight or rain, be careful that heat radiation from
the condenser is not obstructed.
š
There should not be any animal or plant which
could be affected by hot air discharged.
š
Keep the spaces indicated by arrows from wall,
ceiling, fence or other obstacles.
š
Do not place any obstacles which may cause a
short circuit of the discharged air.
š
If piping length is over the [piping length for
additional gas], additional refrigerant should be
added as shown in the table.
PIPE size
Std.
Length
(m)
Min.
Length
(m)
Max.
total
Length
(m)
Max.
Elevation
(m)
Additional
gas
charge
amount
(g/m)
Gas
9.52 mm
(3/8 ʺ )
Liquid
6.35mm
(1/4 ʺ )
5 m/
Indoor
unit
3 m/
Indoor
unit
30 10 15
Note:
(1) It is possible to extend the piping length of one unit up to
20 meters. However, the total piping length must not exceed 30.
(2) If the length exceeds 20 meters, refrigerant of 15g per meter
must be added.
12.1.3 Indoor/Outdoor Unit Installation
Diagram