Panasonic AG-HPX500, Руководство по эксплуатации

Страница: 134 / 152

134
Connecting to External Devices Using the IEEE1394 Connector (PC mode)
C
h
ap
te
r 8 C
o
n
n
ec
tin
g t
o E
xt
er
n
al D
ev
ic
es
To verify data copied to a hard disk
After completing step 4, use the cursor buttons to
select YES for VERIFY in SETUP.
• Data copied from a P2 card will not be affected
even if processing should be interrupted during
verification.
<Note>
• Data cannot be copied from the hard disk to a P2 card.
• Use hard disks under the following conditions.
• Use a separate power supply (not the 1394 bus) to
power the hard disk since this unit cannot supply
power.
• Format the hard disk for this unit.
• Operate hard disks within its operating specifications
(temperature, etc.).
• Do not use hard disks in locations that are unstable or
exposed to vibration.
• Some hard disks may not operate normally.
• During formatting and copying, do not disconnect
cables, do not remove a P2 card that is involved in
any of these activities and do not power off this unit
and the hard disk. Any of these operations will require
turning once off the camera and the hard disk, and then
turning them on again.
• If you first set PC MODE to 1394HOST before
connecting a hard disk (1394.a SBP2 compliant),
normal operation is not guaranteed. Turn the power off
and exit the 1394HOST mode.
• A hard disk is a precision instrument whose read
and write functions may fail in some operating
environments. Please note that Panasonic accepts no
liability whatsoever for data loss or other losses either
direct or indirect arising from hard disk damage or
other defects.
• When the hard disk used to copy data from this unit is
replaced with another device (PC, etc.), the data may
no longer work in this unit and the hard disk data may
have become corrupted.
• It is recommended that you repair bad clips on a P2
card before copying them.
• Use a stable power supply to ensure that copying,
formatting and other operations are not interrupted.
Warnings
• HDD CAPACITY FULL!
There is not enough space left on the hard disk.
• TOO MANY PARTITIONS!
There are too many partitions.
• HDD DISCONNECTED!
The hard disk is disconnected.
• CANNOT INITIALIZE!
The hard disk cannot be initialized.
• TOO MANY TARGETS!
There are too may 1394 connections.
• CANNOT ACCESS TARGET!
The connected device cannot be accessed.
• CANNOT ACCESS CARD!
The card cannot be accessed.
• MISMATCH COMPONENT!
There is a mismatch with the connected device.
• UNKNOWN DEVICE CONNECTED!
A device other than a hard disk is connected.
• P2 CARD IS UNFORMATTED!
The P2 card has not been formatted.
• CARD IS EMPTY! CANNOT COPY!
There is no data on the P2 card to copy.
• VERIFICATION FAILED!
Verification turned up a mismatch.
• TURN POWER OFF!
Turn off the power.
• CANNOT RECOGNIZE HDD!
Hard disk recognition failed.