Panametrics flare.IQ Generation 2, Руководство по эксплуатации и обслуживанию

Страница: 21 / 50

3.3.3 Flare configuration
The flare.IQ Gen 2 is capable of
operating with a wide variety of flare
installations such as steam or air
assist, online gas chromatograph or
calorimeter for BTU measurement, and
multi-flare, single-stack installations.
Depending on the specifics of each
installation, the web console can be
used to configure the flare.IQ Gen 2
during initial set-up. Figure 17 shows
the flare configuration page for the
steam assist option. All quantities
are displayed in English units as
listed in table 7.
All fields in the flare and fuel
configuration pages utilize tooltips.
Tooltips will indicate appropriate
information about the item being
hovered over. Some of the installation-
specific parameters that apply to all
types of flare installations available
on the left side of flare configuration
page are:
• Flare name
• Flare tip diameter
• Flare-to-steam
ratio correction factor
• Flare flowmeter diameter
• Choice of flare assist: steam vs. air
• Choice of continuous velocity
vs. 3-speed air assist
Figure 18 shows a typical steam
assist flare configuration page. Some
installation specific parameters that
may need to be fine-tuned for your
installation can be set on this page
including:
• Low molecular weight (MW)
correction factor
• Normal MW correction factor
• High MW correction factor
• Low MW cut-off
• Normal MW cut-off
• High MW cut-off
• Minimum allowed steam flow
• Maximum allowed steam flow
Your Panametrics field service
engineer can provide in-depth
instructions on the purpose of each
configuration parameter and how to
determine the correct values to enter.
Figure 17: Flare configuration page showing tooltip example
Figure 18: Flare settings for steam assist
21