Paloma PH-246CWHA, Руководство пользователя и инструкции по установке

Страница: 43 / 80

42
SAVE A SERVICE CALL
Check the items below before making a service call. You will be charged for attending to any
condition or fault, which is not related to manufacture or failure of a part (refer to “Terms of the
Paloma Warranty” on page 78).
NO DISPLAY ON THE CONTROLLER
•
Is the controller turned on?
Press the on / off button (refer to “Temperature Control” on pages 10 to 39).
•
Is the water heater plugged in and the power outlet switched on?
•
Is power available in the house?
Try using another electrical appliance.
COLD WATER FROM THE HOT TAP
•
Is the controller turned on?
Press the on / off button (refer to “Temperature Control” on
pages 10 to 39).
•
Close the hot tap, wait 10 seconds and open the hot tap
again.
•
Is the hot tap open enough?
The burners will not light if the flow rate is less than 3.0 L / min.
•
Is the water heater plugged in and the power outlet
switched on?
•
Is power available in the house?
Try using another electrical appliance.
•
Is the isolation valve in the gas line open?
•
Is there a gas supply to the rest of the house?
Try lighting another gas appliance.
•
Has the gas line been purged of air after installation?
Refer to your plumber.
WATER IS TOO HOT OR NOT HOT ENOUGH
•
Does the controller you are using have priority? (refer to “Temperature Control” on pages 10
to 39)
WATER FLOW FLUCTUATES
More than two or three taps in use at the same time may cause a decrease in the hot water flow
from the taps. This can also be evident if the water heater has been installed as an in-series gas
booster to a solar water heater and the solar heated water is at a low temperature.
•
Are there more than two or three taps open, or are appliances such as a dishwasher or
washing machine, in use at the same time?
Ensure only two or three taps or appliances are on at the one time.
•
Check the flow of the water from one tap, e.g. the shower.
The shower should be adjusted so the hot tap is fully open.