MAINTENANCE / REPAIR
TROUBLESHOOTING
OPERATION
ASSEMBLY / INSTALLATION
SAFETY / SPECIFICATIONS
GETTING STARTED
6
A. Control Panel (Interface Control Screen)
Press the hydraulic start button B to start.
B. Hydraulic Pump Start Switch
Press to start the pump and button will light.
C. Emergency Stop Button
Stops and resets the machine parameters. Rotate the button to
release the button and restart the machine.
D. Auto/Manual Switch
This switch changes mode selection between automatic and
manual operation. Use Manual Mode for single cut operations
and Auto Mode for multiple cutting cycles.
E. Operation Start Button
Starts the cutting operation cycle.
F. Bow Up Button and Stop Cycle Cutting
Press to raise the saw bow. The button also stops the
machine’s operation without resetting.
G. Bow Down Button
Press to lower the saw bow.
H. Bench Vise Close Button
Press to approach or clamp the workpiece.
I. Bench Vise Open Button
Press and hold the button to adjust the vise to a desired width.
The button opens one full length when saw bow is at the safe
height. When saw bow is not at the safe height, the vise will
open approx. 3/16” when the button pressed but not held down.
J. Shuttle Vise Close Button
Press to approach or clamp the Shuttle Vise on the workpieces.
K. Shuttle Vise Open Button
Press and hold the button to adjust the vise to a desired length.
The button opens one full length when saw bow is at the safe
height. When saw bow is not at the safe height, the vise will
open approx. 3/16” when the button pressed but not held down.
L. Shuttle Vise Forward Button
Press to advance the vise or workpiece.
M. Shuttle Vise Backward Button
Press to retreat the vise or workpiece.
O. Work Light Switch
Press to light the Work Light. The button light illuminate. Press
again the Work Light will go off.
P. Coolant Switch
Press to start the coolant pump and begin coolant flow. The
button will illuminate. Press again the coolant pump will go off.
R. Power indicator light.
PRESSURE AND DOWN FEED CONTROL
X. Cutting Pressure Knob
This knob sets the rate for the cutting pressure for different
materials.
Y. Bow Down Feed Knob
The knob sets cutting advance rate.
NOTE:
There are five indicator lights on the control panel. They
correspond to the vise and bow rise up or down operation. One is for
shuttle vise movement and two are for vise clamping. They become
illuminated when material is properly clamped in their respective
vises or when the shuttle vise has reached its forward limit position.
The saw bow will not start if the clamping indicator lights are not lit.
OPERATION - DESCRIPTION OF MACHINE PARTS AND FUNCTIONS
The machine control panel
A
C
E
F
K
G
I
H J
B
R
D O
P
L M
X
Y