MAINTENANCE / REPAIR
TROUBLESHOOTING
OPERATION
ASSEMBLY / INSTALLATION
SAFETY / SPECIFICATIONS
GETTING STARTED
14
•
Roughly, the ratio of feed speeds should be 1:2:3. The
materials are listed on the control panel. Please refer to it for
proper cutting pressure setting.
Attaching the nesting clamps (optional)
11B
10B
•
Attach the vertical hex pegs to the stationary vise and shuttle
vise.
•
Place the nestling clamp on to the hex pegs so that the short
side of the clamp faces the motor side. The clamp with the
hose pointing to the motor side (10B) should be placed on
the stationary vise. The clamp with the hose pointing away
from the motor (11B) should be placed on the shuttle vise.
•
Attach the nestling clamps with cap nuts. The hex pegs
should slide freely.
For Shuttle Vise
For Stationary Vise
•
Connect the hydraulic hose fixtures to their fixture heads.
•
The cap nuts may touch the bed slightly, don’t tighten them
too much, otherwise the vise can not move freely forward or
backward.
12B
13B
•
Loosen both side screws (12B) and slide side plate to adjust
the width of vertical press (13B) to suit bundle material width,
after setting tighten the side screws.
•
After setting the width, tighten the side screws.
Attach plates for cutting material width
14B
•
Open the front vise, choose the attach plates (14B). Put
plates on the front vise base for the workpiece width.
•
There are four attach plates. The widths of plates are: two
1-3/16” plates, one 1-5/8” plate, and one 4-3/8” plate.
OPERATION CYCLES
Before starting to cut the workpiece, you must ensure that:
•
The workpiece is well clamped.
•
The saw blade is suitable for the material being cut.
•
The lock lever of the blade guide post is tightened.
•
Sufficient tension is placed on the saw blade.
•
The wire brush is properly positioned.
•
There is sufficient cutting fluid, and it is in good condition.
•
The cutting length and quantity are set already.
•
Preset the cutting pressure and cutting flow rate.
Manual operation
15B
C
X
Y
A
G
H
J
L
R
B
E
I
K
F
D
O P M
•
Connect the main power by turning the switch (15B) to the on
position.
•
Press the Hydraulic Start button (B).
•
Set the Auto/Manual Switch (D) to manual mode.